Philips CRA01/00 Manual do Utilizador

Loop-Through Card Installation Guide Part # CRA01/00 Page 1 of 9 LT Installation Guide 1.1 (140907) 12NC: 3139 1

A. Introduction CRA01/00 is a Loop-Through (LT) interface card designed to support VGA content connectivity and RS232 control in daisy chain configu

D. Loop-Through Card I/O Interfaces 32-pin connector 654321 Connector Application 1 15-pin D-SUB Female VGA Out (Local) 2 15-pin

4. Remove the SmartCard slot cap from the display by removing the two screws circled below. Keep the screws for use in step 8.

7. Insert the LT card into the SmartCard slot as shown below. Ensure that the card is securely connected to the internal 32-pin socket. 8. Secu

F. Connection Instructions 1. VGA The diagram below illustrates the VGA connection configuration to a PC and multiple displays. Important note: T

2. RS232 (Serial Communications) The diagram below illustrates the RS232 connection configuration to a PC and multiple displays. BDLX231 CRA01

The “head” display is working, but the next display (Display 2) doesn’t show an image. 1. Make sure that the VGA input has been selected on Displa

LT Card (CRA01/00) Installation Guide Page 9 of 9 LT Installation Guide 1.1 (140907) 12NC: 3139 125 39281