
1 2
4404.018.33751
Last update: 13/06/12
© Copyright
Addendum
SED-200A 通用型后移相位调光器
AC 220-240V 50Hz LED Luminaire 6-150W
面板
Panel
Dimmer button
Bottom case
Heat sink
Main adjust knob
Power indicator light
Fine tune knob
Fuse
调节旋钮
底壳
散热片
主调旋钮
保险丝
电源指示灯
重要事项 :(使用之前请参阅)
1、产品只适应用于调光此LED照明灯具,不可用于其它灯具。
2、在安装或维修电路时须有专业人员进行操作。
3、请在进行安装或维修电路前,断开市电开关。
4、按照所有国家和当地的电工规定进行安装,请勿拆卸底壳和散热片。
5、仅限室内使用,工作环境温度介于0℃和45℃间。
6、调光器正常工作需要最少总计的灯功率;请勿超过最大额定功率使用。
7、调光器在工作期间摸上去感到温热是正常的。
8、本调光器有过载保护。在使用时超过了调光器额定功率,电路可能被切断,直至
调光器冷却。如果出现该情况,请减少连接至调光器的功率。
9、接线线径为0.75--2.5mm²。
10、接线端子的最大扭矩是0.5Nm,过度拧紧端子螺钉可能会造成永久性的损坏。
11、调节时注意调节力度,以免损坏调光器。
12、本调光器执行IEC/EN60669-2-1标准。
产品部件名称:
SED-200A Universal Electronic Trailing Edge Dimmer
AC 220-240V 50Hz LED Luminaire 6-150W
Product part name:
Important Notes ( Please read before installing):
1.SED-200A is suitable for dimmer this luminaire only , do not connect to other luminaire .
2. Only professional operaters are allowed to install.
3.Turn off mains, before installing or repairing.
4. Install in accordance with all national and local electrical rules. Don’t remove bottom
case and heat sink.
5.For indoor use only , operate between 0°Cand 45°C.
6. Dimmer requires a minimum total lamp wattage.Do not exceed the maximum rating of
the dimmer.
7.It is normal for the dimmer to feel warm when it is working.
8.This dimmer is with overload protection. If the load exceeded the Max wattage, it will
turn off automatically and won’t restart until it cools down. If this occurs, reduce the watt-
age connected to the dimmer.
9. Suitable diameter of the wire is: 0.75 -2.5mm².
10.Maximum torsion for terminal screws is 0.5Nm, overtighten will cause permanent dam-
age to the terminal screws.
11.Operate the knob of dimmer with reasonable strength.
12.This dimmer complies with IEC /EN60669-2-1.
微调旋钮
Comentários a estes Manuais