Philips EM7U LCOS Guia do Utilizador descarregar pdf (Página 56)

Softloadable

Emulations

QMS 4060 Print System Options4-4

5 Open an ftp session at your PC or workstation by typing one

of the following commands:

ftp

printername

↵ (for example, ftp pctdev6↵)

ftp

ipaddress

↵ (for example, ftp 161.33.130.45↵)

6 When prompted for a user name and password, press Enter.

An ftp> prompt displays.

7 At the ftp> prompt, change to binary mode by typing

bin↵

8 At the ftp> prompt, send the emulation file to the printer’s

hard disk by typing

put

filename

.ps↵

where

filename

is the name of the installation file.

The printer’s message window reads 1 Active Job, and the

Disk light flashes to indicate that the emulation is being down-

loaded to the hard disk. The ftp> prompt returns when the emu-

lation has finished loading.

9 At the ftp> prompt, end the ftp session by typing

quit↵

10 When the Disk light stops flashing and the printer’s message

window reads Idle for at least 30 seconds, turn the printer

off and then on again.

11 When the printer’s message window reads Idle again, the

emulation is ready to use.

The emulation should be listed in the Options section of the

printer’s start-up page, in the Administration/Emulation printer’s

configuration menu, and on the advanced status page.

» Note:

You may want to erase any installation files left on your PC

(and/or workstation), and then remove any temporary directories.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 161 162

Sem comentários

Philips EM7U LCOS Guia do Utilizador Página 56