
Hard Disk
Storage
Options
QMS 4060 Print System Options1-4
▲ Caution:
If you connect to this printer an external hard disk you
previously used with an earlier QMS Crown printer (1660E, QMS
1725E, QMS 2025, or QMS 3225), this QMS 4060 Print System
software release will automatically reorganize the files on the hard
disk when the printer is turned back on again. (The printer release
number is listed on both the start-up and the status page.) Once this
reorganization is done, the files on the hard disk can no longer be
accessed if the hard disk is reattached to an earlier QMS Crown
printer.
This reorganization process takes time. If, when you first turn the
printer on after attaching a previously used hard disk, it does not
come on line immediately, be patient. Interrupting the reorganization
process could cause all files on the hard disk to be lost.
Turning on an External Hard Disk
For the printer to recognize one or more external hard disks, each
hard disk must be turned on before you turn on the printer. If the
printer recognizes the disk(s) and the start-up page is enabled, check
to ensure that DISK ONLINE prints on that page. If the start-up page
is not enabled, print a status page and check to see if DISK ONLINE
prints on that page. (See chapter 4, “Printer Configuration,” of the
Reference
manual, for information on how to print a status page.)
If DISK ONLINE does not print, see the
Operation
guide, chapter 9,
the “Internal Hard Disk Problems” section, for more information.
Properly installed disks will also appear in the “Options” section, of
the start-up page (if it’s enabled) and on the status page as
%%disk
x
% (where
x
is a 7 for an internal IDE hard disk and 0 - 6
(SCSI ID 5 is reserved for the scanner) for any external SCSI hard
disks, depending on the SCSI ID set on the back of the hard disk.
Comentários a estes Manuais