Philips PCA460RW Manual do Utilizador

IlllllinillllllllllllllllUlllllir%nurrat LU'ReWntable KitCDRW400seriesOwne/c manual Bediepifnffspniejtun^ Mode d'emplol (itrui/ani per T

Setting your Philips CD Rewriter as the MASTERAs shown in the diagram at the right, insert the jumper pin into the right edge of the jumper switch.Not

Installing your Philips CD Rewriter driveThe following steps may differ slightly, depending on the type of computer you are using. For details on remo

3. Your hands or body may be holding a charge of static electricity.Touch a metallic portion of the chassis or the power supply to discharge the buil

6. Connect the IDE interface connector.Connect the 40-pin IDE interface connector to the IDE interface located on the rear panel of your Philips CD R

AUDIO cableRewriter 4-pin connector (large)To the Sound Card (Sound Blaster compatible)One of the 2 connectors8. Connect the power supply cable.Con

9. Tighten the four fastening screws securely.10. Re-attach the cover to the computer.11. Connect the power cable to an AC outlet, and switch on yo

Chapter 3. OperationFront Panel-[m philips /\lOt Cn.l t II) MoltiRead • DISC •IN USE _____________________)2 3 4 51 Disc trayThe disc is inserted an

6 Eject buttonThis button is used to open or close the tray.7 Manual Eject portThis is used to manually eject a disc that cannot be eject

Ejecting the DiscIf your Philips CD Rewriter is powered-up:Press the eject button to eject the disc.Note; You cannot open the tray if the ATAPI comman

TroubleshootingIf your Philips CD Rewriter is not performing as expected, we suggest you look up the symptoms in the following table, and take the

LASER SAFETYThis CD-RW drive employs a laser. Do not remove the cover or attempt to service this device when connected due to the possibility of eye d

AppendixSpecificationsInterface ATAPI (E-IDE)Data Capacity 650MB (74 minutes disc)Record/Read Speed Writing (CD-RW); 4X speed Writing (CD-R): Normal s

Front Panel Indicator Key•on: green flashing: green Oon: orange □ flashing: orange-offResetReady (no disc) Inserting disc Ejecting disc Ready (disc

IllllllinnillllllllllllllllllllliAdditkNiil Infomiiwp пИйЫе ic (^ur WWW.pCJtU|^rphif|l;pI.COmSpecincuiani lubjcct to chingE 4nlhúuL hü[IC4.Ш diFiEnñmü

COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party: Philips BU PC Add-Ons.Address: Glaslaan 2, 5616 LW Eindhov

WARNINGWarningThe temperature where your Philips CD Rewriter is located should be between 5“C and 40°C (41°F - 104°F), when used in a fan

Table of ContentsIntroduction ...

IntroductionThank you and congratulations for purchasing this Philips Philips CD Rewriter drive. Please read this manual before using the drive in ord

Chapter 1.System ConfigurationBefore using your Philips CD Rewriter, make sure that you have all of the items on the list of included items.In

DiscsYou may use conventional CD-RW and CD-R discs with your Philips CD Rewriter.Philips recommends you use only Philips CD-RW and CD-R discs

Chapter 2.Installing your Philips CD Rewriter DriveMASTER/SLAVE settingsBefore you install your new Philips CD Rewriter in your computer, y