Philips CED228/98 Manual do Utilizador descarregar pdf

CED228

ENG Quick Start Guide

English

Overview of parts

These are the supplierd parts needed to connect and install this unit.

a Carry case with front panel stored inside

b Trim plate

c Standard connector

d Rubber cushion

e Removal keys x 2 pcs

f Screw x 5 pcs

Connect wires: ISO connectors

Pull out the ISO connectors from the

car dashboard and connect them to

the bigger end of the supplied standard

connector.

Connect the other end of supplied

standard connector to the unit.

Do the other connections, if applicable.

Connect wires: without ISO connectors

Cut off the bigger end of the supplied standard connector.

Check the car’s wiring carefully, then connect them to the standard connector.

Connector Connect to

Black wire A metal surface of the car

First connect the black ground (earth) lead, then connect the

yellow and red power supply leads.

Yellow wire The +12V car battery which is live at all times.

Orange/white wire Illumination switch

Red wire The +12V power terminal which is live in the accessory

(ACC) position of the ignition switch

If there is no accessory position, connect to the +12V car bat-

tery terminal that is always live. Be sure to connect the black

JURXQGHDUWKOHDGWRDPHWDOVXUIDFHRIWKHFDUÀUVW

Green and green/black wires Left speaker (Rear)

White and white/black wires Left speaker (Front)

Gray and gray/black wires Right speaker (Front)

Purple and purple/black wires Right speaker (Rear)

Connect the supplied standard connector to the unit.

Do the other connections, if applicable.

Connect parking brake cable

Connect reverse driving cable

1 2

ENG Quick Start Guide 1
4.75-5.56 mm 2

Resumo do Conteúdo

Página 1 - ENG Quick Start Guide

Register your product and get support atCED228ENG Quick Start GuideEnglishOverview of partsThese are the supplierd parts needed to connect and install

Página 2 - 4.75-5.56 mm

Attach the front panel Mount in the dashboardNoteFor proper operation of the DVD player, the chassis must be mounted within 20 degree horizontal. Ens