Philips 42HFL3684S/F7 Guia de Início Rápido descarregar pdf (Página 7)

42HFL3684S 46HFL3684S 39HFL3684S

Channel installation

This section describes how to install the TV channels

automatically.

Connect the RF signal to the TV.

Plug the power cord into the power outlet.

Cable

Turn the TV on.

46HFL3684S, 42HFL3684S

•

Press

( POWER) at the rear of the TV or use the

( POWER) on the remote control.

39HFL3684S

•

Press

POWER at the front of the TV or use the

( POWER) on the remote control.

Press RC5 SETUP to put the remote control into setup

mode, then press the HOME/MENU button to display

the setup menu. (Hereafter, HOME/MENU will be

simply referred to as MENU)

Select Consumer TV setup - Setup - Autoprogram ;

then select Cable. (unless the installation is using only

Antenna signals - in which case you would select

Antenna)

Note

• The TV will not tune any channel that has not been ﬁ rst

“installed”. This includes SPI direct tune commands!

LC11_PHILIPS_hospitality_EN_QG.indd 7LC11_PHILIPS_hospitality_EN_QG.indd 7 2013/03/07 15:30:592013/03/07 15:30:59

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Philips 42HFL3684S/F7 Guia de Início Rápido Página 7