Philips GC5050/02 Manual do Utilizador descarregar pdf (Página 13)

Problem Possible cause Solution

The iron is plugged

in, but the soleplate

is cold.

There is a connection problem. Check the mains cord, the plug and the

wall socket.

The iron does not

produce any steam.

There is not enough water in the

water tank.

Fill the water tank (see chapter ‘Using

the appliance’, section ‘Filling the water

tank’).

The iron is not hot enough to

produce steam.

Wait until the Smart light has stopped

ashing and lights up continuously.

You did not move the iron. This iron is equipped with a motion

sensor and starts producing steam as

soon as it is moved.

The iron is not plugged in. Plug in the iron to switch it on.

The iron does not

produce any steam

when moved.

Although the Auto Steam Sensor

technology covers a large number

of ironing movements, there may

still be some movements that do

not activate the sensor.

Press the steam trigger to start

steaming.

The iron continues to

steam when it is not

moved.

Because of the Auto Steam Sensor

Technology, steam may continue

to be produced for 1-4 seconds

to ensure good wrinkle removal at

the end of the ironing stroke. This is

normal.

If you want to avoid this, place the iron

on its heel.

The iron does not

produce Steam Boost.

You have used the Steam Boost

function too often within a very

short period.

Continue ironing in horizontal position

and wait a while before you use the

Steam Boost function again.

The iron is not hot enough. Wait until the Smart light has stopped

ashing and lights up continuously.

Water droplets drip

onto the fabric during

ironing.

You have not closed the cap of the

lling opening properly.

Press the cap until you hear a click.

You have put a chemical in the

water tank.

Rinse the water tank and do not put any

perfume or any chemical in the water

tank.

The Smart light ashes

slowly.

The Safety Auto-off mode is active.

The iron has been switched to

standby mode(see chapter ‘Safety

Auto-off’).

To reactivate the iron, press the steam

trigger. The iron starts heating up again.

Dirty water and

impurities come out

of the soleplate or the

soleplate is dirty.

Impurities or chemicals present in

the water have deposited in the

steam vents or on the soleplate.

Clean the soleplate with a damp cloth.

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 45 46

Comentários a estes Manuais

Sem comentários

Philips GC5050/02 Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Ferros Philips GC5050/02